Coolant Level Inspection
1
Expansion tank
2
MAX mark
3
MIN mark
4
Fluid level
Position the motorcycle on level
ground and in an upright position.
The
coolant
expansion tank can be inspected
without removing any covers.
Check the coolant level in the
expansion tank.
must be between the 'MAX' (upper
line) and 'MIN' (lower line) marks. If
the coolant is below the minimum
level, the coolant level must be
adjusted.
level
within
The coolant level
Classic Cycles Technical Resources
Maintenance and Adjustment
Coolant Level Adjustment
Do not remove the expansion tank
or radiator pressure cap when the
engine is hot. When the engine is
hot,
the
expansion tank will be hot and also
under pressure. Contact with this
hot, pressurised coolant will cause
scalds and skin damage.
Allow the engine to cool.
the
1
Intake cover
2
Intake cover screws
Remove the intake cover as follows:
Release the two screws from its front
and rear edges and then slide it
downwards to release it from two
support studs in its centre.
Warning
coolant
inside
the
61