Triumph Rocket III Manual page 87

Undo the fixing
headlight clamp to the headlight
body.
Support the headlight while removing
the clamp.
Remove the headlight from its bowl
while supporting it to prevent the
cables from being over extended.
Disconnect the multi-pin electrical
connector from the headlight bulb
and remove the rubber cover.
Detach the wire retainer from its clip
(do not remove the screw) then
remove the bulb from the light unit.
To remove the position light bulb:
Without pulling on the wires, ease the
bulb holder from its socket. The bulb
is removed from its holder by pulling
gently upwards.
Installation for both bulbs is the
reverse of the removal procedure.
Tighten the headlight clamp to 4 Nm.
Maintenance and Adjustment
securing the
Classic Cycles Technical Resources
Caution
When reconnecting the battery,
connect the positive (red) lead first.
Warning
Do not reconnect the battery until
the assembly process has been
completed. Premature battery
reconnection could result in ignition
of the battery gases causing risk of
injury.
87