Installation - GRAUPNER 34002 Manual

Installation

34001_HB_V1
While installing the Vector unit into a glider or model, note:
1. Mark the glider or model's center of gravity and install bat-
tery and unit accordingly. This allows the model to fly prop-
erly by itself.
2. For a pulling motor, install the Vector unit tilted 1-2° upwards.
For a pushing motor, install the Vector unit 1-2° downward.
This gives the unit a little ascending elevator effect while
accelerating and prevents the model from flying downward
while accelerating.
3. The pushing or pulling point on the drive gear thrust:
• must always be at least 10-20mm before the center of
gravity according to the wing geometry
• or just after the wing front edge according to the wing
geometry (for example, see LEO No.13301)
• must always be on the wing
• or wide under the wing (for example, see Hexe No.13304)
4. Do not restrict or limit the propeller airflow. Constricted air
flow reduces thrust and shortens flight time as well as neg-
atively impacts the control reaction.
5. Affix the Vector unit by screwing it through the fixture arms,
attaching it on each side with strips of adhesive tape or with
contact glue (for example, UHU por).
17 / 20