Successful Binding Process
Unsuccessful Binding Process
Binding Multiple Units
Installing and Upgrading Propellers
!
34001_HB_V1
If the binding process was successful, the transmitter will imme-
diately begin controlling the unit.
If the binding process was unsuccessful, move the transmitter
3 feet (1 meter) from the receiver, and repeat the binding process
as needed until a successful bind is achieved.
This function is designed for pilots who want to build and fly cus-
tom-designed multi-channel models. The Vector Unit is very ver-
satile and can accommodate up to 12 channels for channel
mapping.
Binding multiple units is possible only if the function is supported
by the transmitter. Refer to the transmitter's manual for more
information. The process would be described in the Binding
Multiple Receivers or Change Model sections of the trans-
mitter's manual.
CAUTION
To avoid injury by rotating propeller(s) in case of accidental motor
starts, always unplug the battery connector plug prior to removal/
installation.
Propeller removal:
Hold the motor by the motor case, not by the motor mount.
Pull the propeller straight out.
Propeller installation:
Hold the motor by the motor case, not by the motor mount.
Gently push the propeller onto the motor shaft. Do not use
excessive force.
Pay careful attention to the motor turning direction: clock-
wise (CW) or counter-clockwise (CCW).
Pay careful attention to the propeller profile (curvature).
Pay careful attention to the turn direction of the propeller.
Pay careful attention to the incisions on the propeller.
Pay careful attention to the air flow arrow.
13 / 20