Rotor Preparation; Prepare The Sample; Inject The Sample Into Tubes; Keep The Tubes Balance - Scilogex D2012 User Manual

High speed mini micro-centrifuge
Table of Contents

Advertisement

USER MANUAL

7. Rotor Preparation

7.1 Prepare the samples
7.2 Inject the samples into tubes
CAUTION
● Do not overload samples into the centrifuge which will cause leaking.
●Do not exceed the actual capacity allowed in the user manual.

7.3 Keep the tubes balance

●Although the centrifuge can accept sample balancing by eye, we recommend that you keep this centrifuge in a well-
balanced condition to extend its life expectancy.
●Never intentionally run the centrifuge under unbalanced condition even though the allowable imbalance is not
exceeded.

7.4 Inspect the rotor

Check the rotor for corrosion or scratches before using.
CAUTION
● Any abnormality such as corrosion or scratches are found, stop using the rotor and contact our service center.
● Only manufacturer's rotors must be used with the unit.

7.5 Symmetrically load centrifuge tubes to rotor

● Make sure the rotor lid is securely fixed on the rotor, as well as the rotor and shaft are tightened. Otherwise, the
rotor may be moved off while rotating and cause damages of the centrifuge and rotor.
Page 10
www.scilogex.com

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the D2012 and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents