Lochinvar EcoForce EF80 Installation, Commissioning, User And Maintenance Instructions page 73

Menu D: General
D 1 0 -
Function for the external control of the Water heater by using
a 0-10 Volt signal (Connections 15-16).
0 = No external control
1 = Control based on temperature setting
2 = Control based on power setting
Menu D: General
D 2 0 -
Function for the external control of the Water heater by using
a 0-10 Volt signal (Connections 15-16).
Control based on temperature (setting 1).
The minimum (desired) CH water temperature when
supplying a 1.4 Volt signal.
Menu D: General
D 3 A
Function for setting the location height (above sea level)
of the Water heater.
NOTICE: dimensions in English feet. One unit = 100 ft.
Use this function only in consultation with the supplier/manufacturer.
Menu D: General
D 4 M a
Function for setting the maximum overrun time of the fan
(Maximum 10 minutes).
0 = Switch off
Menu D: General
D 5 T e m p O n D
Function to show the (measured) temperature of the Water heater at the
display.
Menu D: General
D 6 D H
Function to set up the CH and HW Water heater options.
0 = CH only (direct)
1 = CH/HW function (indirect)
2 = HW only (direct)
1 0 V c o n
0
1 0 M i n T m p
2 0 °
l t * 1 0
0
x C o o l T
2 M
i
1
W 1 = i 2
1
t r
C
0 f
i m
i n
s p
= d
The Screen Text on these pages show
Parameters used on our EF water heater
and also our CPM Boilers. Certain
functions may not apply to the appliance
you are working on. If there is any doubt
contact Lochinvar Limited.
73