Lochinvar EcoForce EF80 Installation, Commissioning, User And Maintenance Instructions page 53

By pressing (◄ ►) one
can toggle though the
available menus.
"TIME/DATE/DAY" menu
In this menu one can set the time and
the date.
"SETPOINT" menu
In this menu one can change
temperature settings without the need
for a password.
- Hot water set point
Calorifier or Water heater (depends
on heater type)
- Hot water reduced
The amount of degrees diff. relative
to "Hot water set point" during night
reduction.
- Local set point water heater
The temperature of the hot water
supply from the DHW appliance
to the tank is set here.
"PROGRAM" menu
In this menu one can set the DHW
and Anti Legionnella program.
"OPERATING HISTORY" menu
Shows burning hours DHW, etc.
parameter menu
Enter PW Level 1:
three second message
confirming access:
LEVEL 1
HOW TO CONFIRM CHANGES
When changes have been made in one of the nine menus below,
the user presses ENTER to confirm these changes.
To prevent anyone from making changes by mistake, the following
happens when changes are made:
Step 1: The user presses [ENTER] to confirm the change made
or [MENU] to exit the menu without changes. HINT: First
programme all changes planned, then only after that, press
[ENTER]
Step 2: The display asks the user to be sure to make these
changes. The user can cancel or confirm by using the left and right
arrows.
CANCEL = ◄
Enter PW Level 2:
three second message
confirming access:
LEVEL 2
CONFIRM = ►
"FAULT HISTORY" menu
press: ▼ Reading last fifteen faults
(only reading!).
"MAINTENANCE" menu
By pressing (◄ ► ) one can set the
following options:
- Maintenance reset
- Maintenance Mode
- All
- Date
- Ignition cycles
- Burning hours
- Mainten Off
"USER LOCK" menu
In this menu one can lock the menu
for users
0= UNLOCKED
1= LOCKED
When un-locked the user can enter
the "MENU" by pressing the menu
button and all submenus will show.
When locked the user has to push
the : MENU and simultaneously
press ▼ for six seconds to get
access to all submenus.
This is to prevent accidental changes!
NOTE: The parameters sub menu
can always be accessed.
"PARAMETER" menu
In this menu one can change
parameters. The possible access
depends on the password that is
used.
Enter password
53