Table of Contents
Advertisement
6
D. Liquid and pneumatic connections
E. Platform/pump assembly
Figure 3:
TE-3000 rear view with alignment bolt highlighted
area on the right side of the unit is necessary to allow access to the rear
pump switch. An electrical service MAINS power outlet must be located
within nine feet of the TE-3000.
The lower Control Chassis should be placed on the table first followed by
the upper Bath Vessel Housing which is placed on top of the Control
Chassis. The rear mounted alignment bolt on the top rear of the lower
Control Chassis must mate with the hole in the alignment bracket on the
bottom rear of the upper Bath Vessel Housing (see Figure 3). A 1/4-20
hex nut is provided to secure this mating arrangement and should only be
finger-tightened.
The pneumatic connections on the TE-3000 provide the bath agitation
and subsequent stirring by recirculating the bath vapors. Two silicon tube
assemblies are provided which have plastic quick-connect bayonet style
connectors on their ends. These tubes are connected from the air in/out
connections on the bottom Control Chassis to the air out/in connections
on the upper Bath Vessel Housing. There are female connectors on both
ends of one hose and male (black o-ring visible) connectors on both ends
of the other hose. The hose with the female connectors mates with a male
connector on the lower chassis and a male connector on the upper housing.
The hose with the male connectors mates with a female connector on the
lower chassis and a female connector on the upper housing. They all secure
with an insertion and a 1/8 turn lock.
The platform and pump assembly may be completed with the following
items provided by CANNON
Overflow Platform & assembly screws (2)
Reciprocating Pump
Pre-cut tubing (approx. 11", 6" & 3" lengths)
CANNON
®
TE-3000 Thermoelectric Constant Temperature Bath
Version 1.1c — May, 2005; CANNON
2139 High Tech Road • State College, PA 16803 • USA
:
®
®
Instrument Company
Advertisement
Table of Contents
