Positioning Ccs Components; Computer Connections - Cannon CCS-2100 Instruction & Operation Manual

6

Positioning CCS components

Sample Tray

Computer connections

RS-232 serial connections
ment Company, it should be packed in its original shipping container. You
must call CANNON
return information at the conclusion of this manual).
1. Place the CCS on a stable laboratory bench or table.
2. Place the computer adjacent to the CCS.
3. Use the key provided to open the hinged door protecting the Simula-
tor Mechanism.
4. Remove any pieces of foam packing that may have been included to
prevent shipping damage
to internal moveable
components.
5. Close the hinged door.
6. Place the CCS-2100
Sample Tray on the
Simulator Mechanism
Sample Table so that the
arrow on the tray is
aligned with the arrow on
the left guide of the
Sample Table (see
photo). The gear on the underside of the Sample Tray must engage
the gear in the center of the base of the instrument. When the align-
ment is correct, the CCS sampler mechanism at its default position
(farthest left) will be centered over sample #1 on the Sample Tray.
Ensure that the computer specifications meet the minimum requirements
for your CCS instrument. These requirements are listed on the Computer
Specifications sheet provided with your Instruction & Operation Manual.
Locate the RS-232 (25-pin) CCS Control Cable. Connect one end to the
COM port on the rear of the computer. Connect the other end of this
cable to the socket on the rear of the CCS Series II Controller (note that
the connectors are "D" shaped, and fit only one way).
® CCS-2100 with VISCPRO
CANNON
Version 2.0a — November, 2010; CANNON
2139 High Tech Road • State College, PA 16803 • USA
®
prior to returning any products (see warranty and
Sample Tray (top view) correctly
aligned on Sample Table (guides
® Instruction & Operation Manual
® Instrument Company