Safety Precautions
Always observe these signs and instructions. You must observe cautionary messages and warnings in
order to protect yourself as well as prevent others from physical injury or property damages.
Overheat Thermistor
A thermistor in the bath senses any over-temperature fault condition. If such a condition occurs, all
power is removed from the bath until an operator resets the over-temperature limit circuit.
Thermistor Detection/Cutoff
If the control thermistor is disconnected, all power to the bath heaters is
Liquid-Level Control Float
Bath operation is not possible unless it is filled with liquid to a safe operating level. A liquid-level
control float prevents the control circuit from heating the bath until the safe operating level is
attained. The bath heaters automatically turn off if the bath liquid drops below the minimum safe
level.
•
Only qualified personnel should operate the CT-1000.
•
Place the CT-1000 on a stable surface such as a laboratory table or bench. Do not place
instrument on a cart or stand.
•
If any liquids are spilled into the electronic components of the CT- 1000, contact Cannon
Instrument Company immediately.
•
Position power cords so they will not be walked on or pinched by items placed on or against
them. Keep all connections as neat as possible.
•
Unplug the power cord from the wall outlet if the CT-1000 will not be used for an extended
period of time. Disconnect the power cord by pulling it out by the plug. Never pull on the cord.
•
Read and understand all operating instructions and safety precautions listed in this manual
before installing or operating the instrument. Any questions regarding instrument operation or
documentation should be referred to Cannon Instrument Company.
•
Do not deviate from the installation, operation, or maintenance procedures described in this
manual. Improper use of the CT-1000 may result in a hazardous situation and may void the
manufacturer's warranty.
CANNON Instrument Company® | Introduction/Installation
cut off.
5