Assignment And Connection Of The V3D Terminal Block - Procon V3D Series Instruction Manual

H - I - J
 ASSIGNMENT AND CONNECTION OF THE V3D TERMINAL BLOCK
0÷10V
(0)4÷ 0
2 mA
Three-colour LED (green: On, yellow: Operate, red: Error)
SA1 +10 V potentiometer driving output (max. 6 mA) (+15 V option)
SA2 Analogue input 1: potentiometer (2÷10 kΩ), 0÷10 V (200 kΩ), 4÷20 mA (0÷20 mA) (200 Ω)
SA3 GND/A (reference point of the analogue inputs)
SA4 Analogue input 2: potentiometer (2÷10 kΩ), 0÷10 V (200 kΩ), 4÷20 mA (0÷20 mA) (200 Ω)
SD1 Digital input 1 * (factory setting: start switch)
SD2 Digital input 2 * (factory setting: reversing switch)
SD3 Digital input 3 * (factory setting: jogging)
SD4 Digital input 4 * (factory setting: error acknowledgement)
SD5 Option (Digital input 5 *, or IRE(A) input)
SD6 Option (Digital input 6 *, or IRE(B) input)
+24 V/D supply voltage output (max. 100 mA)
ST1
In case of PNP logic the common point of the digital inputs
GND/D (the reference point of the +24 V/D supply voltage output)
ST2
In case of NPN logic the common point of the digital inputs
CST Terminal serial line connector (CAN option, e.g. Master/Slave)
CSR Option (System serial line and/or CAN)
SR1
Digital output 1 ** (factory setting: ready)
SR2
SR3
Option (Digital output 2 **) (factory setting: operate)
SR4
* Switching level of the digital inputs: 0.6 to 2 mA
** Digital outputs: relay (max. 250 V AC / 1 A or 30 V DC / 0,5 A) or optocoupler (optional) (max. 30 V DC / 10 mA)
i
The analogue inputs 1 and 2
configuration includes them, they are connected to the terminals of other functions (mostly to SD5 and 6)
FREQUENCY CONVERTERS INSTRUCTION MANUAL
M
~
U V W PE
MOTOR
1K2
12V
12V
SA
1 2 3 4 1 2
2-10K
(or
R BRAKE
NPN
+24V/D
GND/D
PNP
SD ST
3 4 1 2
(K1, K2
(K1, K2
analogue inputs 3 and 4) are not equipped with own terminals. If the
- 10 -
3 x 400VAC
F1 F2 F3
L1 L2 L3 PE
LINE
CST CSR SR
1 2
jumpers)
jumpers)
0,55 ÷ 200 kW