Required Distances; Figure 30: Fixing Dimensions And Distances Are In Mm - Emerson Copeland Eazycool OMTE-90D-TFD Application Manuallines

Where multiple units are to be installed in the same location, the contractor needs to consider each
individual case carefully. There can be many variations of unit quantities and available space and it
is not the intention of this manual to go over these. However, in general terms, air by-pass around
each condenser and between the units should be avoided always.
Ideally, the unit should be mounted level on a solid concrete slab with anti-vibration pads between
unit feet and concrete. However, the OMTE & OLTE large outdoor condensing units have also been
designed for wall mounting on suitable brackets. In this case it is equally important that the
dimensional guidelines given in chapter 3.5 "Required distances" are followed and that additional
consideration is given for possible air recycling if units are stacked above and below each other. Wall
mounting brackets are not included.
Another factor to consider in finding a good installation site is the direction of the prevailing wind. For
example, if the air leaving the condenser faces the prevailing wind, the air flow through the condenser
can be impeded, causing high refrigeration temperatures and ultimately resulting in reducing the life
of the unit. A baffle is a remedy for this situation.
3.5

Required distances

Figure 30: Fixing dimensions and distances are in mm

C6.1.9/0219/E 31