Creating A Video Conference (Multiway™) - Cisco TelePresence Series User Manual

Cisco TelePresence System Profile Series, Codec C Series, Quick Set C20, SX20 Quick Set, MX200, MX300
Table of Contents
Creating a video conference
(Multiway )
™
If your video system is equipped with the optional
Multiway feature you may call more than one to initiate
a video conference.
The maximum number of participants in a Multiway
conference depends entirely on the video
infrastructure implemented in your organization. If in
doubt, consult your System Administrator.
If you want to initiate a video conference, you must
call each participant one by one.
Note that the current call (or group of calls) must be
put on hold before you call the next participant.
Call settings. Those you call may have video systems
with different capabilities. One of them may, for
example, be on an ADSL system with limited bandwidth
(compared to the others). You may then set the Call
settings to a (normally lower) call rate suiting his or
her system before you call that person. However,
that call rate will affect that specific part of the video
conference only. Other participants will not experience
a lower call rate because of this.
See also the article Video conferencing—calling more
on page 15
than one (optional)
D14582.09 User guide Profile Series, Codec C Series, Quick Set C20, SX20 Quick Set, MX200, MX300
All contents are copyright © 2010–2013 Cisco Systems, Inc. All rights reserved. Version TC6.0, 01.2013
Getting started Video meetings
.
Scheduled meetings
Place a call to the first
participant.
Call the next
participant in the usual
way.
Repeat the procedure from , if
needed.
A maximum four video systems
(yourself included) and one audio call
may participate.
If you initiated the conference you will be able to terminate the entire conference as well.
The other participants, however, may only disconnect themselves from the conference.
17
Managing Contacts The Settings
To add another
one, tap Hold (a)
followed by Add (b)...
Tap Add to place the second
call, initiating a conference. You
may adjust Call Settings before
you place the call, if needed.
Tap END to terminate the
conference.
User guide
www.cisco.com