Krups EA 80 Series Use And Maintenance page 67

Problem
No steam comes
out of the steam
nozzle (25).
There is not enough
frothed milk.
The frothed milk is
not thick enough.
The auto-cappuc-
cino accessory (op-
tional) does not
suck up the milk.
After filling the water
tank (14), the water
tank indicator light
(9) remains lit.
The cleaning or descaling programme will not start.
After emptying the
used coffee collec-
tor (11), the "collec-
tor" indicator light
remains lit.
Probable causes
The nozzle or the nozzle support is
blocked.
Check that steam is coming out of
the nozzle.
Check if the small air inlet in the
upper part of the nozzle is blocked.
The recipient and milk are not cold
enough.
The milk is not fresh enough.
Check if the two ends of the small
stainless steel tube are connected to
the steam nozzle.
Check that the accessories are
connected correctly to one another
and that they are not blocked.
The water tank is not fitted correctly.
The float at the bottom of the tank
does not move freely.
The water tank is scaled.
The used coffee collector is not fit-
ted correctly.
The used coffee collector has been
refitted too quickly.
The cleaning drawer is not fitted
correctly.
Use and maintenance / SERIE EA 80xx
KRUPS Espresseria Automatic
Corrective actions
✗ Remove the steam nozzle
from its support and unblock
these two parts using the clea-
ning wire.
✗ Temporarily remove the Claris
cartridge.
✗ Unblock the steam nozzle with
the cleaning wire.
✗ Unblock the inlet, dry it and if
necessary rinse it with water.
✗ Make sure the recipient and
milk are cold before frothing.
✗ We recommend using very
fresh pasteurised or UHT milk.
✗ Correct the position of the
stainless steel tube
✗ Correct the position of the
stainless steel tube.
✗ Connect the accessories cor-
rectly to one another and un-
block them if needed.
✗ Fit the water tank correctly.
✗ Rinse the water tank under
water and descale if required.
✗ This programme is only possi-
ble when the appliance requests
it ("calc" (6) or "clean" (7)
indicator light lit).
✗ Refit the used coffee collector
correctly.
✗ In general wait for at least 10
seconds before refitting the
empty collector.
✗ Check that the cleaning dra-
wer has been fitted correctly
31