Dispensing Hot Water; Maintenance And Daily Cleaning; Cleaning The Milk System - Bosch TES 713 Series Operating Instructions Manual

en
Tip: For optimal milk froth quality, use cold
milk with a fat content of at least 1.5 % if
possible.
Important: Dried milk residue is difi cult
to remove, so the milk frother 10 must be
cleaned with lukewarm water immediately
after use (see "Cleaning the milk system").

Dispensing hot water

Risk of burns!
¡
The milk frother 10 gets very hot. After use,
allow to cool down i rst before touching.
The appliance must be ready for use.
● Place the pre-warmed cup or glass under
the outlet of the milk frother 10.
● Select the required setting for "Hot water"
Ê
by turning the knob 6.
● Press the start button 8. Hot water runs
out of the milk frother outlet 10 for about
40 seconds.
● Press the start button 8 again to cut the
process short.
N.B.: It is possible to set the temperature of
the hot water (see "Menu settings").
Maintenance and daily
cleaning
Risk of electric shock!
¡
Unplug the appliance before cleaning it.
Never immerse the appliance in water.
Do not use a steam cleaner.
● Wipe the outside of the appliance with
a soft, damp cloth. Do not use abrasive
cloths or cleaning agents.
● Always remove any limescale, coffee,
milk or descaling l uid residue immediate-
ly. Such residue can cause corrosion.
● Rinse the water tank 11 and the brewing
unit 23 with water only.
TES713_H1.indb 43
● The drip tray panel 25 and the cover
of the milk container 30 should only be
wiped gently with a damp cloth.
Do not put them in the dishwasher.
● Remove cup stand 27. Pull the drip tray
26 with the coffee grounds container 28
forward and out, then empty and clean
them. All the parts can also be cleaned
in the dishwasher.
● Remove drawer 20 and clean.
● Clean the measuring spoon 14, the aro-
ma cover 16 and the milk container 30 by
hand or in the dishwasher.
● Wipe out the inside of the appliance (tray
holders).
Important: Drip tray for coffee outlet 26
and coffee grounds container 28 should be
emptied and cleaned daily to prevent mould
from developing.
N.B.: If the appliance is cold when switched
on, or if it is switched off after dispensing
coffee, it rinses automatically.
Important: If the appliance has not been
used for a prolonged period of time (e.g.
after a vacation), clean the entire appliance
thoroughly, including the milk system 10
and brewing unit 23.

Cleaning the milk system

Important: The milk system 10 must be
cleaned immediately after use!
The milk system 10 can be pre-cleaned
automatically (see "Service Programmes")
or cleaned manually.
43 43
TES713 | 04/2012
25.04.2012 18:56:45