Before Using For The Irst Time - Bosch TES 713 Series Operating Instructions Manual

32 32
Dear Coffee Connoisseur,
Congratulations on purchasing this fully
automatic espresso machine from Bosch.
Please also note the enclosed quick refer-
ence guide.
It can be kept in the special storage com-
partment 24 until it is needed.
Before using for the i rst
time
General
Fill the water tank with fresh, cold, uncar-
bonated water only, and preferably use only
beans for fully automatic coffee and espres-
so machines.. Do not use coffee beans that
have been glazed, caramelised or treated
with other additives containing sugar, since
they will block the brewing unit.
The water hardness setting can be adjusted
on this appliance. The factory default set-
ting for the water hardness is 4. Check the
water hardness with the enclosed test strip.
If a value other than water hardness 4 is
displayed, change the setting on the appli-
ance accordingly after switching on (see
"Menu settings" ‒ "
Switching on the appliance
● Place the fully automatic espresso ma-
chine on a l at, water-resistant surface
that can take its weight.
Important: Only use the appliance in
frost-free rooms. If the appliance has been
transported or stored at temperatures below
0 °C, wait at least 3 hours before operation.
● Pull the power cord out of the storage
compartment 29 and plug in. Adjust the
length of the cable by pushing it back in
or pulling it out. The easiest way to do
this is to place the appliance so that its
back is l ush with the edge of the counter
and either pull the cable downward or
push it upward.
Robert Bosch Hausgeräte GmbH
TES713_H1.indb 32
Water hardness
").
● Lift the lid of the water tank 12.
● Remove and rinse the water tank 11 and
i ll it with fresh cold water.
Do not i ll above the "max" mark.
● Replace the water tank 11 and push it
i rmly downward into place.
● Close the lid of the water tank 12 again.
● Fill the bean container 15 with coffee
beans.
● Press the power switch 1 O / I. The start
button 8 lights up and the different lan-
guages appear in the display 5.
<
● Use the buttons and
language in which you want the display
texts to appear.
Sprache
Deutsch
English
Français
The selected language is highlighted by
a frame. The following languages can be
selected:
Deutsch
English
Français
Italiano
● Press the start button 8. The language
you selected is saved.
en
>
4 to select the

start
25.04.2012 18:56:43