Tips On Energy Saving - Bosch TES 713 Series Operating Instructions Manual

48 48
Open drawer
● Open the drawer 20 by pressing.
Insert Bosch cleaning tablet and
close drawer
● Drop a Bosch cleaning tablet in the draw-
er 20 and close.
Note: If the water ilter is activated, the
display 5 will prompt you to remove the ilter
and press the start button 8 again.
Remove filter
Add 0.5 l water and descaler

start
● Pour lukewarm water into the empty wa-
ter tank 11 up to the "0.5" litre mark and
dissolve 2 Bosch descaling tablets in it.
● Press the start button 8. The descaling
pro gramme now runs for about 20 minutes.
Descaling
Not enough descaling fluid.

Refill fluid
Note: If there is not enough descaling solu-
tion in the water tank 11, the corresponding
prompt is displayed. Pour in descaling solu-
tion and press start 8 again.
Clean and refill water tank

start
● Rinse the water tank 11 and reill it with
fresh water up to the "max" mark.
● Press the start button 8. The descaling
pro gramme now runs for about 1 minute
more, followed by the cleaning pro-
gramme for about 7 minutes, and rinses
the appliance.
Descaling
Cleaning
Empty drip tray
Replace drip tray
● Empty drip tray 26 and replace.
Robert Bosch Hausgeräte GmbH
TES713_H1.indb 48

start
start
Replace the ilter if one is being used.
The appliance has completed descaling and
cleaning and is ready for use again.
Important: Wipe down the appliance using
a soft, damp cloth to immediately remove
any descaler residue. Such residue can
cause corrosion.
N.B.: If one of the service programmes is
interrupted, e.g. by a power outage, pro-
ceed as follows:
● Rinse the water tank 11 and reill it with
fresh water up to the "max" mark.
● Press the start button 8. The cleaning
pro gramme now runs for about 3 minutes,
and rinses the appliance.
Cleaning
Empty drip tray
Replace drip tray
● Empty drip tray 26 and replace.
The appliance is ready for use again.

Tips on energy saving

– The display has a dimming function that
switches on automatically when the ap-
pliance is not in use. The display is il-
luminated dimly. Press any button or the
rotary knob to brighten the display illumi-
nation again.
– If the appliance is not being used, switch
it off at the power on / off switch 1 O / I on
the front.
– If possible, do not interrupt coffee or milk
froth dispensing. Cutting the coffee or
milk froth dispensing process short re-
sults in higher energy consumption and in
more residual water collecting in the drip
tray.
– Descale the appliance regularly to avoid
a build-up of limescale. Limescale residue
results in higher energy consumption
en
25.04.2012 18:56:46