Water Ilter; Transport. Lock; Factory Reset - Bosch TES 713 Series Operating Instructions Manual

40 40
● Dip the test strip in the water briel y and
check the result after 1 minute.
Level
German (°dH)
1 1-7
2 8-14
3 15-21
4 22-30
j >
Water filter
3 sec. +
Before a new water i lter is used, it must be
rinsed.
● To do this, press the water i lter i rmly
into the water tank 11 with the aid of the
measuring spoon 14. Fill the water tank
with water up to the "max" mark.
● Turn the knob 6 to select
press the start button 8.
Place 0.5 l container under milk
●

frother start
● Place a container with a capacity of 0.5
litres under the milk frother 10.
● Press the start button 8. Water will now
l ow through the i lter to rinse it.
● Next, empty the container. The appliance
is ready to use once more.
Note: Rinsing the i lter simultaneously
activates the setting for the "change i lter"
display.
You can i nd detailed information about the
water i lter in the enclosed i lter instructions.
Robert Bosch Hausgeräte GmbH
TES713_H1.indb 40
Water hardness
French (°fH)
1-13
14-25
26-38
39-54
start
and
The i lter is no longer effective when the
change filter
display appears, or at
the latest after 2 months. It needs to be
replaced for reasons of hygiene and so that
there is no build-up of limescale (this could
damage the appliance).
Replacement i lters can be obtained from
retailers (TCZ7003) or from customer service
(467873). If no new i lter is used, turn the
Water filter
setting to
Note: If the appliance has not been used
for a prolonged period (e.g. vacation) the
i lter should be rinsed before the appliance
is used again. To do this, simply dispense a
cup of hot water.
j >

Transport. lock

3 sec. +
● To avoid damage from low temperatures
during transport and storage, the appli-
ance must be completely emptied i rst.
Information: The appliance must be ready
for use and the water tank 11 i lled.
● Press the start button 8. The appliance
automatically empties the pipe system
and switches off.
● Empty the water tank 11 and the drip tray
26.
j >

Factory reset

3 sec. +
You can cancel your own settings and reac-
tivate the factory settings.
● To activate the factory settings, press the
start button 8.
Note: The appliance can also be reset to
the factory settings using a combination of
buttons. The appliance must be switched
off fully.
<
● Hold down the and
the on / off switch 1 O / I at the same time
for at least 5 seconds. Press the start
button 8. The factory settings are now
reactivated.
en
no
.
>
buttons 4 and
25.04.2012 18:56:45