Cisco MX200G2 Manual page 9

Create an In-room Control panel
Table of contents
Start Designing the In-room Control Panel
Introduction
If an existing in-room control panel failed to load automatically on
launching the editor, choose one of these alternatives:
Create a user interface Create a user interface
•
•
API for in-room control
•
Widgets
All alternatives erase any unsaved data in the editor, but the existing
in-room control panel on the video system is neither overwritten nor
deleted until a new panel is exported to the video system.
Command reference
Troubleshooting
Tips and tricks
Examples
In-Room Control on Touch 10
for Cisco TelePresence
MX200 G2, MX300 G2,
MX700, MX800,
SX10, SX20, SX80
Collaboration Endpoint
software version CE8.2
D15358.02 - JULY 2016
www.cisco.com
© 2016 Cisco Systems, Inc.
All rights reserved.
Create creates a blank in-room control panel in the editor for
either Global use, Homescreen use or In-Call use.
Import > From file loads an in-room control panel, which has been
exported to a local file on an earlier occasion, into the editor.
Import > From codec loads the current in-room control panel from
the video system into the editor. Not available in the offline editor.
Start or continue the design of an in-room control panel
9