Cisco MX200G2 Manual page 39

Table of contents
To stop movement after long pressing, short press any button (stop
button is not really necessary)
Introduction
Remove an entire in-room control panel and icon
Create a user interface
If there is an in-room control panel on the video system then there
is also a corresponding in-room control icon, either in the Touch 10
status bar or as a button to the right of the call control buttons. Even
API for in-room control
if a panel is empty and contains no widgets, both the icon and the
panel will be visible.
Perform the following steps to remove the in-room control panel and
Widgets
icon from Touch 10:
Command reference
Troubleshooting
Tips and tricks Tips and tricks
Examples
In-Room Control on Touch 10
for Cisco TelePresence
MX200 G2, MX300 G2,
MX700, MX800,
SX10, SX20, SX80
Collaboration Endpoint
software version CE8.2
D15358.02 - JULY 2016
www.cisco.com
© 2016 Cisco Systems, Inc.
All rights reserved.
a. Launch the in-room control editor from the video system's
web interface.
b. Select the panel to be removed (Global, Homescreen or In-
call)
c. Click Recycle bin ( )in the lower right corner.
39