Installation Hardware And Tools; Choosing A Location; Preparing The Site - Wavion WBS-2400 Installation Manual

Outdoor wi-fi base station

Hide thumbs Also See for WBS-2400:

Table of Contents

Installation Hardware and Tools

Wavion provides the following accessories to install the Wavion WBS-2400:

• One pole bracket

• Two 4-6-inch diameter worm drive hose clamps

• Seven 8mm stainless steel hex head machine bolts

• Allen wrench - 4mm and 5mm

• Six Antennas

You must supply the following tools:

• 1/4-inch flat blade screwdriver

• Wood brace mounting only: four 5/8-inch diameter, 3-inch long lag bolts

The Wavion WBS-2400 is a radio device and susceptible to interference that can reduce

throughput and range. To ensure the best performance follow these guidelines:

• Direct line-of-sight operation is preferred.

• It is recommend not to install the WBS-2400 near devices operating in the 2.4 GHz

frequency range.

• The WBS-2400 should be installed at the highest point of a metal pole such that there will be

no interference caused by RF reflections. If this is not possible, the WBS-2400 should be

installed at least 3 meters from the metal pole.

• It is always best to have the maximum distance possible from an RF radiating source.

When installing the Wavion WBS-2400, you must follow the appropriate electrical and building

codes to ensure safe and durable wiring. Follow the National Electrical Code (NEC)

requirements, unless local codes in your area take precedence over the NEC code.

For installations that have 10/100 Base-T Category 5 network cables attached to the Wavion

WBS-2400, there is a distance limit of 100m maximum between devices for 10/100BaseT

operation.

An appropriate ground cable should be available. Grounding through electrical wiring or CAT-5

cable is not sufficient.

Please refer to standards for building entrance protection.

Installation Guide

Table of Contents