Quantum StorNext M660 Hardware Manual page 79

StorNext M660 Metadata Appliance Hardware Guide
Note: This procedure must be used any time the VIP address needs to
be changed after initial system configuration.
1 Open an ssh connection to the M660 using the IP for the MDC node
operating as the primary from either the customer's LAN client or
Metadata network.
2 Log on using the stornext credentials. The default password is
"password".
3 Type the sudo rootsh command to grant root user privileges after
entering the password for the stornext user account again when
prompted.
4 From the command line, update the VIP Address using the following
command (refer to the vip_control man page or the
Pages Reference Guide
vip_control
5 To update the firewall rules for the MDC node operating as the
primary, type the following:
/opt/DXi/scripts/netcfg.sh --reset_snvip
6 Close the ssh connection for the MDC node operating as the
primary.
7 Open an ssh connection to the M660 using the IP for the MDC node
operating as the secondary.
8 Log on using the stornext credentials. The default password is
"password".
9 Type the sudo rootsh command to grant root user privileges after
entering the password for the stornext user account again when
prompted.
10 From the command line, update the VIP Address using the following
command (refer to the vip_control man page or the
Pages Reference Guide
Chapter 3: Basic System Operations
Additional Common Operations
for information on changing the address).
for information on changing the address).
StorNext Man
StorNext Man
73