Garmin G1000 Pilot's Manual page 341

After the data has been copied to both data cards, perform the following steps:
1) Insert one card in the bottom card slot of the MFD and one in the bottom card slot of the PFD.
2) Apply power to the G1000 System. View the MFD power-up splash screen. Check that the Terrain and Obstacle
databases are initialized and displayed on the scrolling window of the splash screen.
3) Acknowledge the Power-up Page agreement by pressing the ENT Key or the right most softkey.
4) At the MAP – Navigation Map Page, select the MAP Softkey and check to make sure that the TOPO and
TERRAIN softkeys are functional (not grayed out).
5) Power down the G1000.
190-00592-02 Rev. A
Figure B-1 Power-Up Splash Screen Window
Garmin G1000 Pilot's Guide for the Diamond DA40/40F
APPENDIX B
B-3