Garmin G1000 Pilot's Manual page 328

APPENDIX A
G1000 SYSTEM MESSAGE ADVISORIES
This section provides information regarding G1000 message advisories that may be displayed by the
NOTE:
system. Knowledge of the aircraft, systems, flight conditions, and other existing operational priorities must
be considered when responding to a message. The Pilot's Operating Handbook (POH) takes precedence
over any conflicting guidance found in this section.
This section describes various G1000 System message advisories. Certain messages are issued due to an LRU
or LRU function failure. Such messages are normally accompanied by a corresponding red 'X' annunciation as
shown previously in the G1000 System Annunciations section.
PFD/MFD MESSAGE ADVISORIES
Message
DATA LOST – Pilot stored data was
lost. Recheck settings.
XTALK ERROR – A flight display
crosstalk error has occurred.
PFD1 SERVICE – PFD1 needs service.
Return unit for repair.
MFD1 SERVICE – MFD1 needs
service. Return unit for repair.
PFD1 CONFIG – PFD1 configuration
error. Config service req'd.
MFD1 CONFIG – MFD1
configuration error. Config service
req'd.
SW MISMATCH – GDU software
mismatch. Xtalk is off.
MANIFEST – PFD1 software
mismatch. Communication halted.
MANIFEST – MFD1 software
mismatch. Communication halted.
PFD1 COOLING – PFD1 has poor
cooling. Reducing power usage.
MFD1 COOLING – MFD1 has poor
cooling. Reducing power usage.
PFD1 "KEY" KEYSTK – Key is stuck. A key is stuck on the PFD and/or MFD bezel. Attempt to free the stuck key by
MFD1 "KEY" KEYSTK – Key is
stuck.
CNFG MODULE – PFD1
configuration module is inoperative.
PFD1 VOLTAGE – PFD1 has low
voltage. Reducing power usage.
MFD1 VOLTAGE – MFD1 has low
voltage. Reducing power usage.
A-6
The pilot profile data was lost. System reverts to default pilot profile and settings.
The pilot may reconfigure the MFD & PFD with preferred settings, if desired.
The MFD and PFD are not communicating with each other. The G1000 System
should be serviced.
The PFD and/or MFD self-test has detected a problem. The G1000 System should
be serviced.
The PFD and/or MFD configuration settings do not match backup configuration
memory. The G1000 System should be serviced.
The MFD and PFD have different software versions installed. The G1000 System
should be serviced.
The PFD and/or MFD has incorrect software installed. The G1000 System should
be serviced.
The PFD and/or MFD is overheating and is reducing power consumption by
dimming the display. If problem persists, the G1000 System should be serviced.
pressing it several times. The G1000 System should be serviced if the problem
persists.
The PFD configuration module backup memory has failed. The G1000 System
should be serviced.
The PFD1 voltage is low. The G1000 System should be serviced.
The MFD1 voltage is low. The G1000 System should be serviced.
Garmin G1000 Pilot's Guide for the Diamond DA40/40F
Comments
190-00592-02 Rev. A