Removing A Headlamp; Changing A Bulb - Ford Escape 2014 Owner's Manual

1
1
E129990
2. Press the locking buttons together.
3. Rotate and remove the wiper blade.
4. Install in the reverse order.
Note: Make sure that the wiper blade locks
into place. Lower the wiper arm and blade
back to the windshield. The wiper arms will
automatically return to their normal position
when the ignition is turned on.
To change the rear blades, do the
following:
1. Lift the wiper arm.
2
E130060
2. Slightly rotate the wiper blade from the
wiper arm.
3. Disengage the wiper blade from the
wiper arm.
Escape/Kuga (CBS) Australia, Vehicles Built From: 08-09-2014, TF 19A321 AD enAUS
Maintenance
2
3
4. Remove the wiper blade.
5. Install in the reverse order.
Note: Make sure that the wiper blade locks
into place.
Replace wiper blades at least once per
year for optimum performance.
Poor wiper quality can be improved by
cleaning the wiper blades and the
windshield.

REMOVING A HEADLAMP

E159160
1. Make sure the lighting control is in the
off position and open the hood.
2. Remove the three screws from the
headlamp assembly.
3. Carefully pull the headlamp assembly
as far as possible toward the front of
your vehicle to disengage it from the
lower fixing point.
4. Carefully lift the outer side of the
headlamp and remove it.
5. Disconnect the electrical connector.

CHANGING A BULB

WARNINGS
Switch the lamps and the ignition off.
196