Table of Contents
Advertisement
Selecting the Line Voltage
CAUTION: If you are using the RAS 2000 PowerRack with 220- 240 VAC, you MUST
NOTE: The RAS 2000 PowerRack is designed to operate at ambient tempera-
tures in the range of 10
The RAS 2000 PowerRack has a line voltage selector switch on the back of the
chassis, between the two power plug receptacles (see Figure 2-2).
NOTE: The switch is factory set for 115 VAC.
switch to the 230V position. If you do not do this, you will cause permanent dam-
age to the RAS 2000 PowerRack. Damage resulting from failure to follow these
instructions is not covered under warranty.
RAS 2000 PowerRack Hardware Guide
o
o
o
o
- 35
C (50
- 95
F).
Page 2-5
Advertisement
Table of Contents
Need help?
Do you have a question about the IntelliServer RAS 2000 PowerRack and is the answer not in the manual?
Questions and answers