Crestron CP4-R Product Manual page 118

Pyng os 2
Hide thumbs Also See for CP4-R:
Table of Contents

Advertisement

The following Ethernet settings may be edited in the Settings panel.
Authentication: Tap On to turn device authentication on, or tap Off to turn
device authentication off.
If authentication is turned on, an Enable Authentication dialog box is displayed.
Enter a username and password in the appropriate fields, and then reenter
o
the password. Tap OK to proceed.
A pop-up dialog box is displayed that provides warnings about authentication
o
and steps for connecting to the system after authentication is enabled.
Enable Authentication Confirmation Dialog Box
Tap OK to proceed or Cancel to cancel enabling authentication.
o
CAUTION:
password required for authentication, as the Crestron Pyng system may not
be accessed without these credentials. If the authentication credentials are
lost, the CP4-R must be restored to factory defaults.
CIP Port: Enter the CIP port number for the CIP routing protocol.
Secure CIP Port: Enter the secure CIP port number for the CIP routing protocol.
CTP Port: Enter the CTP port number for the CTP routing protocol.
Secure CTP Port: Enter the secure CTP port number for the CTP routing
protocol.
Web Port: Enter the web port number for the hypertext transfer protocol.
Secure Web Port Enter the secure web port number for the hypertext transfer
protocol.
112 • Crestron Pyng OS 2 for CP4-R
Once authentication is enabled, do not lose the username and
Product Manual – DOC. 8432A

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CP4-R and is the answer not in the manual?

This manual is also suitable for:

Cp3-r

Table of Contents

Save PDF