Sawmill Maintenance - Wood-mizer LT15 Series Safety, Setup, Operation & Maintenance Manual

machine damage.
CAUTION!
travel limits. Damage to the up/down system may result.
CAUTION!
not only prevent the blade from being pulled off and ruined by a wood sliver,
but also will increase the life of the blade.
CAUTION!
adjusted for low cuts. Remove the loading ramps before sawing to prevent
damage to the saw head and/or blade guide arm.
CAUTION!
bigger dry powder extinguisher.
1.5

Sawmill Maintenance

CAUTION!
screw. If either of the bellows is damaged, replace it immediately. Before
installing the new bellows, clean the up/down screw and nut thoroughly with
extraction naphtha and then grease them.
CAUTION!
If the wiper presses too firmly against the bar, it can cause the power feed
to bind.
CAUTION!
See Table 1-1. Pictogram decals used to warn and inform the user about danger in the LT15.
Decal View
Safety & General Information
Do not try to force the saw head beyond its upper and lower
Be sure to stop the blade when returning the carriage. This will
The saw head will hit the spring-loaded ramp stops when
The sawmill's work-stand should be equipped with a 4 kg or
The up/down screw bellows should completely cover the
Reinstall the track wiper so that it lightly touches the track bar.
Never use grease on the mast rails as it will collect sawdust.
W-M No.
096317 CAUTION! Read thoroughly the manual
before operating the machine. Observe all
safety instructions and rules when
operating the sawmill.
15doc120709
Safety & General Information
Sawmill Maintenance
Description
1
TABLE 1-1
1-3