Parking Brake; Cutting Height Adjustment - Snapper ZF2100DKU, ZF2300GKU, ZF5200M, ZF6100M Safety Instructions & Operator's Manual

Section 2 - OPERATING INSTRUCTIONS
2.2.4.

PARKING BRAKE

1. Engage parking brake by pulling the parking
brake lever back to the "ON" position. See
Figure 2.8.
2. Release parking brake by moving brake lever
down to the "OFF" position. See Figure. 2.9.
JOYSTICK IN
NEUTRAL
POSITION
PARKING
BRAKE
LEVER IN
ENGAGED
"ON"
POSITION
FIGURE 2.8
FIGURE 2.9
PARKING BRAKE
DISENGAGED "OFF"
POSITION
9
2.2.5.

CUTTING HEIGHT ADJUSTMENT

1. Adjust cutting height as desired to any
position, using deck lift switch. When in desired
height of cut, release switch. See Figure 2.10.
Observe the height of cut decal located on the
upper right top side of the deck to place deck at
the correct height of cut. See Figure 2.10.
NOTE: The engine does not have to be running
to adjust cutting height, but key switch must be
in the "ON" position.
DECK HEIGHT OF
CUT DECAL
FIGURE 2.10
WARNING
DO NOT park the machine on slopes. DO NOT leave
machine with engine running. Stop engine. Stop
blades. Engage parking brake. Remove key.
DECK LIFT
SWITCH