Enter New Pin; Privacy Zone Setup - Dedicated Micros Dennard 2040 Menu System Manual

4.3.5 Enter New PIN

The PIN number for the supervisor is pre-programmed but can be changed by the supervisor
through the following screen:
Enter new PIN _ _ _ _
0 1 2 3 4 5 6 7 8 9
Accept Entry
Clear Entry
Return Without Change
Key in your new PIN (password) and accept the entry.
Make a note of the new PIN number and keep it in a safe place

4.3.6 Privacy Zone Setup

The final option on the Supervisor Menu allows specific areas within view of the camera to be
blanked out, preventing the operator from monitoring or storing the images from those areas.
Before selecting the feature, ensure that the camera is positioned so that the required area to be
blocked is shown full screen on the monitor. The feature then allows the following options:
Define single zone
Clear single zone
Define multiple zones
Clear all privacy zones
Return
Exit
Selecting 'Define single zone' will make the screen go black as the patch is inserted. As the dome
has returned to normal mode, out of the screen settings, move the camera view away from the area
and the black section will remain in its specific location.
When defining multiple zones the screen will go black and the text 'Privacy zones' will be displayed.
Move the camera to the desired area and press 'Enter' for each zone. When finished, use the key
sequence to enter the menu structure (e.g. #1 for the dtx400) to escape from the feature.
To clear a privacy zone, the camera must be positioned over the zone before selecting the 'Clear'
facility or the "Clear all privacy zones" feature selected. The dome will immediately return to normal
operation after the zone(s) has been deleted.
Dennard 2040 / 2060 Menu System Manual Page. 22