Dexcom STS User Manual
  1. Manuals
  2. Brands
  3. Dexcom Manuals
  4. Blood Glucose Meter
  5. STS
  6. User manual

Dexcom STS User Manual

For transmitter model number 9300 and receiver model number 8204
Hide thumbs
1
2
3

Advertisement

Table of Contents

D
C
™ STS™ C
EX
OM
F
T
OR
RANSMITTER
STS™ Sensor & STS™ Applicator
Starting Continuous Glucose Monitoring
S
1- Inserting a New STS™ Sensor
TEP
Choose a site on your abdomen (belly) to put the Sensor that is a flat area and where you don't have any scarring or rough patches
of skin and clean the site with an alcohol swab. Remove the adhesive backing from the STS™ Sensor Pod and place the STS™
Sensor on the selected site.
1.
Pull the safety lock out from the Applicator.
2.
Place 2 fingers under the collar, with your thumb on the plunger, and push the plunger down completely.
3.
At the same time that you are pushing the plunger down, pull the collar back completely until you hear a click.
4.
Press the tabs on the sides of the STS™ Sensor Pod and pull out the STS™ Applicator.
Safety Lock
1.
2.
Caution: Investigational device. Limited by Federal (United States) law to investigational use.
G
ONTINUOUS
LUCOSE
M
N
9300 & R
ODEL
UMBER
STS™ Sensor &
STS™ Transmitter
Push plunger
Pull Collar
3.
CONFIDENTIAL
Under FDA Review
M
S
ONITORING
YSTEM
M
ECEIVER
ODEL
Collar completely back
4.
4.
STS™ Sensor Pod remains adhered
Press tabs
U
G
SER
UIDE
N
8204
UMBER
STS™ Receiver
Remove STS™ Applicator
Page 1 of 3

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the STS and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Dexcom STS

Summary of Contents for Dexcom STS

  • Page 1 Choose a site on your abdomen (belly) to put the Sensor that is a flat area and where you don’t have any scarring or rough patches of skin and clean the site with an alcohol swab. Remove the adhesive backing from the STS™ Sensor Pod and place the STS™...
  • Page 2 Pull the STS™ Transmitter Latch up onto the to STS™ Transmitter to snap it into place. Remove the STS™ Transmitter Latch by holding the end of the latch and quickly twisting off the latch away from your body. Remove STS™ Transmitter Latch STS™...
  • Page 3 When the STS™ Sensor glucose value is above or below the alert settings you have selected (factory settings are 80 and 200), the STS™ Receiver will notify you of a high or low glucose value. Press any button on the STS™ Receiver to acknowledge the alert.

Table of Contents