Operating Instructions - Flex PE 150 18.0-EC User Manual

PE 150 18.0-EC

Operating instructions

WARNING!
Remove the battery before carrying out any
work on the power tool.
Before switching on the power tool
Unpack the polisher and check that there
are no missing or damaged parts.
NOTE
The batteries are not fully charged on
delivery. Prior to initial operation, charge
the batteries fully. Refer to the charger
operating manual.
Inserting/replacing the battery
Press the charged battery into the power

tool until it clicks into place.
To remove, press the release button (1.)

and pull out the battery (2.).
CAUTION!
When the device is not in use, protect the
battery contacts. Loose metal parts may
short-circuit the contacts; explosion and fire
hazard!
Battery state of charge
Press the button to check the state of

charge at the state of charge indicator
LEDs.
The indicator goes out after 5 seconds.
If one of the LEDs flashes, the battery must
be recharged. If none of the LEDs light up
after the button is pressed, the battery is
faulty and must be replaced.
Attaching tool holder
Remove the battery.

Press and hold down the spindle lock (1.)

Screw tool holder (Velcro plate) in

clockwise direction onto spindle and
tighten by hand (2.).
Secure tool on tool holder.

Insert the battery.

Switch on the polisher (without

engaging it) and run the polisher for
approx. 30 seconds. Check for
imbalances and vibrations.
Switch off the polisher.

19