3Replacing The Starter Of The Color Developing Unit - Canon iR C6800 Series Service Handbook

- if for the CMY
COPIER>FUNCTION>INSTALL>INISET-3
16) Execute the following service mode item:
COPIER>FUNCTION>MISC-P>P-PRINT.
away the generated printout in the service book case.
(If there is a previous printout, dispose of it.)
17) End service mode, and start user mode; on the
Auto Gradation Correction screen, follow the
instructions to execute auto gradation correction
(full).
2.4.3 Replacing the Starter
of the Color Developing
Unit
1) Remove the color developing unit.
2) Remove the screw [1], and free the 4 hooks [2];
then, detach the developing unit lid [3].
[1]
[3]
[2]
F-2-31
3) On A3 paper or in a vinyl bag, dispose of the
contents of the unit by turning it over.
F-2-32
developing assemblies,
Store
0004-0874
4) Turn back over the developing unit, and turn the
developing gear in the direction in which the cylinder
normally turns so that the agent will drop into the
developing assembly.
F-2-33
5) Dispose of the agent into a vinyl bag or on paper by
turning over the developing unit.
6) Repeat steps 4) and 5) about 3 times (e.g., until no
agent drops into the developing assembly).
7) Shake the container of the starter about 10 times.
8) Detach the funnel [2] of the starter bottle [1]; then,
detach the middle lid [3], and put the funnel back on
[2].
[2] [1]
F-2-34
9) Pour the starter along the length of the stirring
screw inside the color developing unit so that it is
about half full.
Chapter 2
[3]
2-41