Image Adjustments; 1Image Position; 2Checking The Image Position - Canon iR C6800 Series Service Handbook

Chapter 2

2.1 Image Adjustments

2.1.1 Image Position
The margin and the non-image width of a printout
made at 100% magnification must be as follows:
- Leading Edge Margin
4.0+1.5/-1.0mm
[double-sided copy, 2nd side:4.0+1.5/-1.0mm]
0 2 4 6 8 10 12 14 16 18 20 5
F-2-1
- Left/Right Margin
2.5+1.5mm/-1.5mm
(double-sided copy, 2nd side
:2.5+2.0mm/-2.0mm)
0
2
4
5
6
8
10
F-2-2
- Leading Edge Non-Image Width
4.0+1.5/-1.0mm
0 2 4 6 8 10 12 14 16 18 20 5
F-2-3
- Left/Right Non-Image Width
2-30
0003-8718
F-2-4
2.1.2 Checking the Image
Make 10 prints using the following as the source of
paper; then, check to see if the margin and the non-
image width are as indicated:
1 cassettes
2 manual feed tray
3 left/right front deck
If outside the standards, make the following
adjustments:
1. Leading Edge Image Margin Adjustment (1st side)
Execute the following service mode to adjust the
registration:
COPIER > ADJUST > FEED-ADJ > REGIST
F-2-5
2. Left/Right Image Margin Adjustment
Adjust the horizontal registration mechanically.
3. Leading Edge Image Margin Adjustment (2nd side)
Execute the following service mode items to adjust
the registration:
2.5+1.5mm/-1.5mm
0
2
4
5
6
8
10
Position
decrease the setting of REGIST.
(an increase by 10 will decrease the margin by 1 m
Copy, 1st side:4.0+1.5/-1.0mm
Increase the setting of REGIST.
(an decrease by 10 will decrease the margin by 1 m
0 2 4 6 8 10 12 14 16 18 20 5
0003-8719
Paper leading edge