Table of Contents
Advertisement
iFleetONE™ Terminal Installation Manual
Clearance holes for M6
(Recommended >6.5mm)
In the case of the existing mast's flange on the vessel or ship does not fit the ADU's
mounting base's holes, a custom-made mechanical adaptation flange should be designed
and fabricated so that the flange acts as an interface between the existing mast and the
ADU.
1.5.6 Installing the Antenna Unit
The antenna unit should be carefully unpacked and checked for any damage.
The procedure for the installation of the antenna unit is as follows:
Attach the coaxial cable to the RF connector on the antenna unit's base.
Position the antenna unit at the mounting location.
Check the connection of the coaxial cable and wrap it with self-amalgamating tape for
water-proofing.
Cut-hole Dimension
for
flange
Clearance holes for M6 ( Recommended >6.5mm)
Custom-made
mechanical adaptation
flange
Page 22 of 41
Advertisement
Table of Contents
