Important Safety Warnings
Comply with all warnings and operating instructions in this manual and save it for future reference. Do not
operate this unit before carefully reading through all safety information and operating instructions.
Transportation and Storage
Transport the UPS system only in the original package to protect against shock and impact.
The UPS must be stored in a ventilated and dry room.
Preparation
Condensation may occur if the UPS system is moved directly from cold to warm environments. The
UPS system must be absolutely dry before being installed. Please allow at least two hours for the UPS
system to adjust to the environment.
Do not install the UPS system near water or in damp environments.
Do not install the UPS system where it would be exposed to direct sunlight or near a heater.
Do not block ventilation holes on the UPS housing.
Installation
Do not connect appliances or devices to the UPS output sockets or terminal that would over load the
UPS.
Place cables in such a way that no one can step on or trip over them.
Do not connect domestic appliances such as hair dryers to UPS output sockets.
Connect the UPS system only to a grounded, shockproof outlet, which must be easily accessible and
close to the UPS system.
Use only a VDE-tested, CE-marked (or UL-marked for 100/110/115/120/127 Vac models) mains cable
(e.g. the mains cable of your computer) to connect the UPS system to the building wiring outlet (shockproof
outlet).
Use only VDE-tested, CE-marked (or UL-marked for 100/110/115/120/127 Vac models) power cables
to connect the loads to the UPS system.
When installing the equipment, ensure that the sum of the leakage current of the UPS and the
connected devices does not exceed 3.5mA.
Temperature Rating: Units are considered acceptable for use in a maximum ambient environment of
104°F (40°C).
For Pluggable Equipment: The socket-outlet shall be installed near the equipment and shall be easily
accessible.
The unit is heavy. Lifting the unit requires a minimum of two people.
3