Manually Mounting / Removing The Stylus From The Stylus Module; Tcr20 Rack Kit - Renishaw PH20 Installation And User Manual

PH20 installation and user's guide
www.renishaw.com

Manually mounting / removing the stylus from the stylus module

To fit a stylus onto the probe module, carry out the following procedure:
NOTE: For advice on both stylus and probe module selection, refer to the applications guide later in this publication.
1. Ensuring that you have selected the correct probe module for your given application (see probe module selection later in this guide), screw
the threaded end of your chosen stylus into the M2 stylus mount of the probe module and hand-tighten to secure.
2. Using the type S7 stylus tools provided, or type S20 spanner if fitting a stylus from the Renishaw GF range, fully hand-tighten the stylus
into the stylus mount to achieve the recommended tightening torque of between 0.05 Nm and 0.15 Nm (maximum permissible torque is
0.3 Nm).

TCR20 rack kit

The TCR20 rack, which can be easily mounted onto a CMM, is designed to securely hold stored probe modules for automatic changing.
TCR20 protects stored probe modules from airborne contaminants that may be present within the working environment and also features an
integrated tip datum artefact.
Issued 03 2019
18