Install Handle - Camp Chef Smoke Pro PG24SE-5 Warning & Instruction Booklet

2. Assemble Qty (2) leg brackets onto the legs as shown
in Fig 2 using Qty (4) M6 x 45 Bolts, Qty (4) M6 Flat
Washers, Qty (4) M6 Lock Washers, and Qty (4) M6 Nuts.
Finger tighten hardware.
3. Assemble the wire shelf to the legs as shown in Fig 2
using Qty (4) M6 x 45 Bolts, Qty (4) M6 Flat Washers, Qty
(4) M6 Lock Washers, and Qty (4) M6 Nuts. Finger tighten
hardware.
M6 FLAT WASHER
M6 LOCK WASHER
M6 NUT
Fig. 2
4. Assemble Qty (2) Wheels to the legs as shown in Fig 3
using Qty (2) Wheel Axles, Qty (2) M8 Flat Washers, and
Qty (2) M8 Nyloc Nuts. Tighten axle hardware with a
wrench.
5. With the help of another person, stand the grill upright.
Be careful as the lid on the hopper and grill will close as
the grill is stood upright.
6. Tighten all hardware assembled in the previous steps. Do
not crush the tubes by over tightening the hardware.
M6 X 45 BOLT
M6 LOCK WASHER
Fig. 1
M6 X 45 BOLT
M6 NUT
M6 LOCK WASHER
M6 FLAT WASHER
M6 X 45 BOLT
WHEEL AXLE
M8 FLAT WASHER
M8 NYLOC NUT
Fig. 3
Attach Chimney and Chimney Cap
1. Install chimney to grill as shown in Fig 4. Make sure to
install the gasket between the grill and the chimney.
2. Tighten all hardware.
3. Install 1/4-20 x 3 Bolt through chimney cap and secure
using Qty (1) 1/4-20 nut. Thread second nut onto bolt
leaving approximately 1.5 in to the top of the cap. Thread
cap assembly down into the chimney bracket until the
lower nut hits the bracket. See Fig 4.
4. The height of the chimney cap can be adjusted for
summer and winter. In the summer the gap should be
approximately 1-1/2 in. In the winter the gap should be
approximately ½ in.
5. Tighten all hardware.
1/4-20 X 3 BOLT (1)
1/4-20 NUT (2)
M6 X 15 SCREW
CHIMNEY GASKET

Install Handle

1. Install the handle as shown in Fig 5.
2. Tighten all hardware.
PG24LS-6 (1)
HANDLE
M6 FLAT WASHER
M6 LOCK WASHER
M6 NUT
Fig. 4
M6 FLAT WASHER (2)
M6 LOCK WASHER (2)
M6 NUT (2)
Fig. 5