Mira Vision Installation Manual page 5

Caution!
1. Read all of these instructions and retain this guide for later use.
2. The electrical installation must comply to "BS 7671 (commonly referred to as the
IEE Wiring Regulations) and all relevant regulations, or any particular regulation
or practice specified by the local electricity supply company.
3. The plumbing installation must comply with the requirements of UK Water
Regulations/Bye-laws (Scotland), Building Regulations or any particular
regulations and practices, specified by the local water company or water
undertakers.
4. Make sure that you fully understand how to operate this shower and make sure
that it is properly maintained in accordance with the instructions given in this
manual.
5. DO NOT turn-on the electrical supply until the plumbing has been completed.
6. The appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, unless they are supervised or have been
given instruction concerning the use of the appliance by a person responsible
for their safety.
7. Sunburn or skin conditions can increase your sensitivity to hot water. Make sure
that you set the shower to a cooler temperature.
8. If any of the following conditions occur, isolate the electricity and water supplies
and refer to section "To contact us", in the back cover of this guide.
• If the cover is not correctly fitted and water has entered the appliance case.
•
If the case is damaged.
•
If the appliance begins to make an odd noise, smell or smoke.
•
If the appliance shows signs of a distinct change in performance, indicating
a need for maintenance.
•
DO NOT operate if water leaks from the appliance.
•
DO NOT operate this appliance if it is frozen. If suspected of being frozen,
isolate and contact us for advice.
5