Mira Vision Installation Manual page 31

Run cold water through
(approximately 2 minutes) and
check entire installation for water
leaks. Press " " to turn shower
off. Fit the second hose washer
and showerhead.
Press " " to turn shower on.
Test operation of shower by
increasing/decreasing both
temperature and flow controls.
(See User Guide for full details.)
Test operation of showerhead
spray modes. (See Showerhead
User Guide for full details.)
Refer to User Guide for further instructions on how to use the shower.
The Wireless Controller factory default settings are as follows:
Maximum Showering Temperature = 45°C
Eco Mode
Warm-Up Mode
Clock
Clock Display
= Off
= Off
= 4:00 (when batteries connected)
= On
31