Internet Explorer Setup; Begin Initial Configuration; Installation And Removal Of Power Supply Modules - ATTO Technology ATTO XstreamCORE FC 7500 Installation And Operation Manual

optional Internet Explorer setup below. If not, continue
on to Begin initial configuration.

Internet Explorer setup

1. Open your browser
2. Go to the browser toolbar and select Tools.
3. Select Internet Options.
4. In the Internet Options screen, select the Security tab.
5. Click on the Trusted Sites icon.
6. Click on the Sites button.
7. Uncheck the Require server verification
check box.
8. In the text box Add this web site to the zone, add the IP
address of the appliance. You may use wild cards.
9. Click Close.
10. At the bottom of the Internet Options dialog, click OK.

Begin initial configuration

1. The XstreamVIEW™ interface welcome screen appears.
Click on Enter Here.
2. Type in the user name and password.
The default values are user name root and password
Password. The user name is case insensitive and the password is case
sensitive. It is best practice to change the default user name and
password. Refer to Modify passwords.
E 5 X CORE FC 7500, LED
XHIBIT STREAM
E 8 X CORE FC 7600, LED
XHIBIT STREAM
E 9 X CORE FC 7550, LED
XHIBIT STREAM
, P R P
S OWER ECEPTACLE AND ORTS
,
S POWER RECEPTACLE AND PORTS
,
S POWER RECEPTACLE AND PORTS
3. The XstreamVIEW™ status page appears. Continue to
Map Devices.
Installation and Removal of Power
Supply Modules
1. To remove a power supply module, first remove the
power cord.
2. Press the side latch inward and pull out on the handle
3. To install a power module, insert module until you hear
the latch click.
Handle and latch should be on top.
4. Install power cord.
Remove the power source before removing the power
supply module. Failure to do so may cause injury or damage the unit
15 | P a g e