Table of Contents
Advertisement
The ATTO XstreamCORE has several processors which control the flow of data. The firmware to control these processors can be upgraded in
the field using the PUT command from an FTP connection utility over an RS-232 serial connection. The preferred method is to use ATTO
XstreamVIEW™ System Manager.
The recommended method for updating firmware for the
XstreamCORE is the Firmware Update page in the ATTO
XstreamVIEW™ interface.
The XstreamCORE firmware is distributed as a .zbd file from
the ATTO Technology web site at
the file and note the filename.
There is always a backup image in the XstreamCORE, in
case the flashing process fails. After updating the firmware, verify the
correct program version is executing by viewing the status page and
checking the firmware revision number.
Using XstreamVIEW™
1. If you are not already in the XstreamVIEW™ interface,
type the IP address of your XstreamCORE in a standard
browser as found in Using XstreamVIEW™ System
Manager, click Enter Here, type in your user name and
password, and click OK.
2. Click on the Firmware Update menu item on the left-
hand side of the page.
Update Firmware
www.atto.com.
Download
3.
The Firmware Update page appears. Click the Browse or
Choose File button to locate the firmware that you
downloaded earlier.
4.
Select the file.
5.
Click Upload.
6.
Wait until a success message is displayed.
7.
Click on the Restart button at the bottom of the page.
Using FTP
1.
Establish an FTP link to the storage controller that is to
be flashed.
The FTP connection must be set up for both Active mode
and Binary mode for the transfer to complete correctly.
2.
Use the PUT command to download the firmware file to
the storage controller. For example:
3.
PUT c:\controller_firmware\xc750200.zbd
4.
Once the download is complete, cycle power on the
XstreamCORE to implement the
new firmware.
23 |
P a g e
Hide quick links:
Advertisement
Table of Contents
