Operation
Operation
Pressure Relief Procedure
This equipment stays pressurized until pressure is
manually relieved. To help prevent serious injury
from pressurized fluid, such as skin injection, splash-
ing fluid and moving parts, follow the Pressure Relief
Procedure when you stop spraying and before clean-
ing, checking, or servicing the equipment.
1. Set both (2) pump valves to OFF. Turn engine OFF.
2. Turn pressure control to lowest setting. Trigger all
guns to relieve pressure.
ti3441a
3. Engage all gun trigger locks. Turn both (2) prime
valves down.
ti3324a
8
ti23144a
ti3305a
PAINT
ti6473a
4. Leave drain valve(s) open until you are ready to
spray again.
5. If you suspect the spray tip or hose is clogged or
that pressure has not been fully relieved:
a. VERY SLOWLY loosen the tip guard retaining
nut or the hose end coupling to relieve pressure
gradually.
b. Loosen the nut or the coupling completely.
c. Clear the obstruction in the hose or tip.
Soft Key Message
NOTICE
To prevent damage to soft key buttons, do not
press the buttons with sharp objects such as pens,
plastic cards, or fingernails.
Trigger Lock
Always engage the trigger lock when you stop spraying
to prevent the gun from being triggered accidentally by
hand or if dropped or bumped.
ti26702a
3A3111 A