Software Interface; Interface; Format For The At Commands; Enfora At Command Set - Enfora Enabler LPP G Integration Manual

10. Software Interface

10.1. Software Interface
The application sends commands to the Enfora Enabler LPP G module via the 50-pin I/O signal
connector. These commands use the Enabler LPP G Menu System, Enfora AT Command Set and/or
Enfora GSM-GPRS Family API.
The Enfora Enabler LPP G module operates in one of the following modes:
 Command Menu mode: Used for configuring the Enfora Enabler LPP G module. It uses menu
based commands via the serial port for communication. See LPP0108PR001 - Enfora Enabler
LPP G Programming Reference for more details on specific commands.
 Modem Pass-Thru mode: Used to communicate directly with the modem. It uses the AT
command set via the serial port for communication. Entry to this mode is available via a menu
mode command.
10.2.

Format for the AT Commands

The general format of the command line is: <prefix> <command> <CR>
<prefix>
<command>
<CR>
The prefix AT obtains synchronization, identifies the character parameters, and indicates that a
command may be in the following characters.
AT commands are not case sensitive; use either capital letters or lower-case letters for the AT
command.
Note: Some AT Command parameter values ARE case sensitive and are documented in the
Enfora Enabler-LPP G AT Command Set Reference – LPP0108AT001.
10.3.

Enfora AT Command Set

For a full description of the AT commands, refer to the Enfora Enabler-LPP G AT Command Set
Reference – LPP0108AT001.
Note: A command description that includes an *asterisk denotes that the GSM service provider
must enable supplementary services functionality before the command is available.
LPP0108IG001
AT
See AT Command
Manual
0X0D
60
Version - Preliminary – 06/20/08