Operation; Inserting/Replacing The Batteries - EuroLite LED Disco Strobe for Batteries User Manual

Table of Contents

Advertisement

Available languages

Available languages

The durability of the installation depends very much on the material used at the installation area (building
material) such as wood, concrete, gas concrete, brick etc. This is why the fixing material must be chosen to
suit the wall material. Always ask a specialist for the correct plug/screw combination indicating the maximum
load and the building material.
The device must always be installed via all fixation holes. Do only use appropriate screws and make sure
that the screws are properly connected with the ground.
DANGER TO LIFE!
Before taking into operation for the first time, the installation has to be approved by an expert!

OPERATION

Inserting/Replacing the batteries

Please refer to the explanations under Operating Determinations.
Open the battery cover on the bottom and remove it.
If replacing the batteries, remove the old batteries from the battery compartment. Only replace complete
battery-sets.
Leaky or damaged batteries might cause cauterisation when in contact with the skin; therefore, use suitable
protective gloves.
Caution!
Danger of explosion when battery is replaced improperly.
Only replace by the same type or similar types recommended by the manufacturer.
Remove empty batteries in accordance with the instructions of the manufacturer.
Insert the batteries and make sure that the poles are correct.
Replace the battery cover and close it.
With the ON/OFF-switch, you can switch the device on and off.
If the device will not be used for a longer period of time, remove the batteries in order to avoid battery
leakage.
In order to have a long battery life, you should only use alcaline batteries.
BATTERY DISPOSAL NOTICE
Please dispose of old and used batteries properly.
Batteries are hazardous waste and should not be disposed of with regular domestic waste!
Please take old and used batteries to a collection center near you.
On the rear panel ot the LED Disco Strobe there is a control to adjust the flash frequency ( up to 170 flashes
per minute).
11/12
00062689.DOC, Version 1.0

Advertisement

Table of Contents
loading

Table of Contents