Sherwood RX-773 Operating Instructions Manual page 21

Continued
4.
While the punch-through mode is displayed, repeat the
above steps 2 and 3 to program other punch-through
function under the same master device mode.
Operating a punch-through function
• While this remote control is set to control a master device, aim the remote control at the REMOTE SENSOR of the punch-
through device and press the desired button of the programmed punch-through controls.
Example: When pressing "PLAY (▶)" button.
Erasing the programmed punch-through function
1.
Perform the steps 3 and 4 in "Entering a setup code"
procedure on page 15 to select a master device and
the punch-through mode ("PUNCH").
• Then "VOL" is displayed on the LCD screen for several
seconds.
5.
To program punch-through functions under other
master device mode, repeat the above steps 1 to 4.
• Then the punch-through device is displayed on the
LCD screen.
2.
While "VOL" is displayed, press the CURSOR UP(▲)/
DOWN(▼) buttons to select the punch-through mode
to be erased, then press the ENTER/MEMORY button.
• Each time the CURSOR UP(▲)/DOWN(▼) buttons are
pressed, the mode changes as follows:
→ VOL
DELETE
• Then the device is displayed .
21
CH ←
PLAY