Sherwood RX-773 Operating Instructions Manual page 18

Erasing the programmed command from one button
1.
Perform the steps 3 and 4 in "Entering a setup code"
procedure on page 15 to select the deleting mode
("DELETE").
• Then "BTTN" is displayed on the LCD screen for several
seconds.
2.
While "BTTN" is displayed, press the CURSOR UP
(▲)/DOWN(▼) buttons to select the one command
deleting mode (BTTN), then press the ENTER/
MEMORY button.
• Each time the CURSOR UP(▲)/DOWN(▼) buttons are
pressed, "BTTN" or "LEARN"(all command deleting mode)
is selected.
• Then "SEL" is flickering.
• If "SEL" goes off, start again from the above step 1.
Erasing all the commands programmed under a device mode
1.
Perform the steps 3 and 4 in "Entering a setup code"
procedure on page 15 to select the deleting mode
("DELETE").
• Then "BTTN" is displayed on the LCD screen for several
seconds.
2.
While "BTTN" is displayed, press the CURSOR UP
(▲)/DOWN(▼) buttons to select the all command
deleting mode ("LEARN"), then press the ENTER/
MEMORY button.
• Then "SURE?" is displayed .
• If "SURE?" goes off, start again from the above step 1.
3.
While "SEL" is flickering, press the button for the
command you want to erase.
Example: When the button for the command to be erased
is PLAY button.
• "OK" is displayed and then "SEL" is flickering.
4.
While "SEL" is flickering, repeat the above step 3 to
erase other commands.
3.
While "SURE?" is displayed, press the ENTER/MEMORY
button.
• Then all the commands programmed are erased.
4.
To erase all the commands programmed under other
device mode, repeat the above steps 1 to 3.
18