Sherwood RX-773 Operating Instructions Manual page 31

Continued
3.
While displaying the selected category, select the desired channel.
Presetting channels
• You can store up to 30 preferred channels in the memory.
1.
Select the desired channel with preforming channel
search, direct search or category search.
2.
To memorize the channels, perform the steps 2 to 4 in
"Manual presetting" procedure on page 28.
Displaying XM information
• You can display XM information such as channel name, artist name, song title and signal strength.
• In the XM mode,
or
• Each time the DISPLAY button is pressed, the display mode changes as follows:
→ Channel number/name → Artist name → Song title → Category
Signal strength("GOOD", "MARGINAL", "WEAK", "NO SIGNL") ←
Error message and status
• If an operation takes longer than usual or an error occurs, one of the following messages may be displayed.
Message
ANTENNA
UPDATING
NO SIGNL
LOADING
OFF AIR
or
The XM antenna is not connected correctly. Check the antenna.
The XM user encryption code is being updated. Please wait.
The signal is too weak. Check the antenna connection and reposition it for the best reception.
This receiver is tuning or decoding audio or text data. Please wait.
The selected XM channel is not currently broadcasting. Select another channel.
Preset search
• In the XM mode, select the desired preset channel.
or
Note:
• If the information on artist name, song title or category is
not available, it will not be displayed correctly.
Signal strength display mode
• If the reception is poor, you can check the signal
strength of the XM radio signal and adjust the position of
the XM antenna until "GOOD" is displayed.
Status
31