Sherwood RX-773 Operating Instructions Manual page 19

Programming a macro function
• The macro function enables you to program a series of button operations(up to 15) on this remote control into a single button.
• You can store up to three separate macro command sequences into "M1", "M2" and "M3" buttons.
1.
Perform the steps 3 and 4 in "Entering a setup code"
procedure on page 15 to select the macro mode
("MACRO").
• Then "M1" is displayed on the LCD screen for several
seconds.
• During macro setting operation, pressing any of the
DEVICE buttons cannot exit from the macro mode.
2.
While "M1" is displayed, press the CURSOR UP(▲)/
DOWN(▼) buttons to select the MACRO button to be
programmed into, then press the ENTER/MEMORY
button.
• Each time the CURSOR UP(▲)/DOWN(▼) buttons are
pressed, "M1", "M2" or "M3" is selected.
• Then "SEL" is flickering.
• If "SEL" goes off, start again from the above step 1.
4.
Press any of the MACRO buttons (M1~M3) to complete the programming.
3.
While "SEL" is flickering, press the operation buttons
you want to program in order.
Example : When playing a CD on the CD player connected
①. Press "AUDIO" button to control this receiver.
②. Press "POWER ON" button to turn this receiver on.
③. Press "CD (2)" button to select the desired input
source.
④. Press "CD" button to control the CD player.
⑤. Press "POWER ON" button to turn the CD player on.
⑥. Press "PLAY (▶)" button to start playback.
• Each time the operation buttons are pressed, the
programmed order is displayed.
• Then "OK" is displayed.
To erase a macro program
• When erasing a macro program, perform the above steps 1, 2 and 4, but
ignore the step 3.
To change a macro program
• When a new macro program is stored into a MACRO button with performing
the above steps 1 to 4, the previous macro program is erased from the
memory of the MACRO button.
19
to CD jacks of this receiver.