Sherwood RX-773 Operating Instructions Manual page 17

Programming the commands from other remote controls (LEARNING mode)
• If the setup codes are not available for your component or you want to program a missing or special function into one button of a
device, the learning function enables this remote control to learn the commands from other remote controls.
1.
Place this remote control and other remote control
facing each other at a distance of 5 to 15 cm (2 to 6
inches ) apart.
2.
Press and hold down the ENTER/MEMORY button
and the desired one of the DEVICE buttons for more
than 2 seconds.
• Then "LEARN" is displayed on the LCD screen for several
seconds
Note : During setting operation, to exit from the setting
mode, press any of the DEVICE buttons.
3.
While "LEARN" is displayed, press the ENTER/MEMORY
button.
• Then "SEL" is flickering.
• If "SEL" goes off, start again from the above
step 2.
4.
While "SEL" is flickering, on this remote control, press
the button corresponding to the function to be learned.
Example: If the function to be learned is playback, press
the PLAY(▶) button.
• Then "READY" is displayed.
Note : You cannot program a function into some buttons
such as DEVICE, MACRO and LIGHT buttons.
5.
While "READY" is displayed, on the other remote
control, press the button of the function to be learned.
• If the command has been learned successfully, "OK" is
displayed and then "SEL" is flickering.
• If "ERROR" is displayed and then "SEL" is flickering, it
means that for some reason the command was not
learned. In this case, repeat the above steps 4 and 5.
Notes :
• If an incorrect signal has been sent or, in some cases, the
command from other remote control simply cannot be
learned.
• In some "ERROR" cases, the remote controls just need to
be moved closer together or farther apart.
6.
While "SEL" is flickering, repeat the above steps 4 and
5 to program all the commands you want to the
buttons on this remote control under the same device
mode.
To exit from the setting mode, press any of the
DEVICE buttons.
7.
Repeat the above steps 1 to 6 to program the
commands from a different remote control.
8.
Operate the newly programmed buttons to make sure
the learning function was performed properly.
17